How To Add A 240v Circuit Breaker In Parallel

Adding a 240-volt circuit breaker in parallel with another is a relatively easy task, but it requires careful planning and attention to detail to make sure everything is done safely and correctly. This guide will walk you through the steps necessary to install a new 240-volt circuit breaker in parallel, from gathering materials to the final installation.

When installing a circuit breaker in parallel, it's important to make sure that the power is shut off before beginning. This can be done by turning off the main breaker and then turning off the individual circuit breaker that you'll be adding the parallel breaker to. Once the power is shut off, the next step is to gather the necessary materials. This includes the 240-volt circuit breaker, a hammer drill, a screwdriver, wire strippers, and a set of pliers.

Once all the materials have been gathered, the installation can begin. The first step is to attach the breaker to the panel box. This is done by attaching the breaker into the appropriate slots on the side of the box. Once the breaker is secure, use the hammer drill to create a hole in the wall behind the panel box, making sure the hole is large enough for the wires to fit through. Next, run the wires through the hole and connect them to the terminals on the breaker. Make sure the wires are secure and connected to the correct terminals.

Now it's time to connect the breaker to the ground bar. This is done by stripping the insulation off of the ends of the wires and connecting them to the proper terminals on the ground bar. Once the wires are securely attached, the breaker can be installed into position. This is done by slipping the breaker over the screws and tightening them down with a screwdriver.

Finally, the last step is to connect the breaker to the other circuit breaker that it's in parallel with. This is done by inserting the wires into the slots on the side of the circuit breaker and tightening the screws down until they are snug. Again, always make sure the wires are connected to the correct terminals.

Adding a 240-volt circuit breaker in parallel is not a difficult task, but it does require care and attention to detail to ensure everything is done correctly and safely. With the right materials and following this guide, the process should be relatively easy and take little time.

Do I Need A Circuit Breaker Victron Community